Wiper control Cable

[JohnC]

Good morning all. When I got the car, the wiper control cable was disconnected from the wiper motor. I now have a new switch with a new cable attached to it but I can't find any info on how it gets attached to the wiper motor. The cable just has a little nub on the end. Any photos or drawing will be much appreicated .

Thanks

[Barry Wolk]

It fits into the sliding rubber valve. That?s what controls everything.

[JohnC]

Good Morning all,

20220728_164503.jpg This is a pic of my wiper motor with the original cable on it. It looks attached but it was just laying on top.

20220730_113623.jpg Here is a pic of the top of my wiper motor. I can see how the cable lays in there and clamps down with that screw. Is there anything missing on it?

20220730_113112.jpg Here is how I set my cable in there. I don't think it's right. When I turn the knob on the wiper control to the right, there is a lot of pressure on it and it wants to spring back, like it's binds up on something.

Thanks

[Barry Wolk]

Does the rubber valve section move? You may have to take it apart to free it up. The big black part has to move too, I believe.

[JohnC]

Yes...the big black part moves back and forth and also the part that it is connected too (is that the rubber valve section you are referring too). I'm wondering if the cable is seated right?

[Barry Wolk]

I'll take a photo of mine today.